VISITOR PREAMP

2022/03/19 : Sold Out. 

VisitOR gets you that thick heavy vintage gain often sought after for stoner/doom guitar tones. 

I've always been found of the OR120 sound and for a long time was using a JFET recreation of the preamp circuit for my own purposes at home. I set out a ways back to start recreating a similar sound without the use of all those JFETs and this is the end result. Since I built this for around home, I'm offering the other units here as a limited release. I wouldn't be opposed to doing a run depending on the response of these builds.

Run this pedal into your FX return, direct to interface, or in front of the amp.

Controls

• Gain – Overdrive grit to crushing distortion.
• Mass – Adjust the low end depth of the signal in the gain stage.
• High / Mid / Low – Passive tone controls.
• Level – This is your standard volume attenuator.

Power

• 9-18V – Use a "boss style" 2.1mm center negative 9-18V power supply. 

Switching

• True Bypass – Soft click (1.1KGf) mechanical 3PDT
• LED Brightness (internal trim) – Adjust the brightness of the bypass LED

Demos